Bend wires at right angles

Bends a wire in a right angle and makes three right angle turns to avoid or add geometry.

You can modify the wire defined at a right angle. You can replace the right angle bend while maintaining the original wire connections to the components.

Note: This tool terminates if the bend attempts to connect two different wire networks or if the bend bypasses more than a single right-angle turn.

1. Click Schematic tab Edit Wires/Wire Numbers panel Modify Wires drop-down Bend Wire.
2. Select one of the two wires that make up a right-angle turn.
3. Select the opposing wire that makes up the right-angle turn.

   The additional wire segments are added based on the right-angle direction.

4. Right-click to exit the command.

You can modify the wire defined at a right angle. You can replace the right angle bend while maintaining the original wire connections to the components.