Changing Playback Speed

Use the Retime option to change the playback speed of your shots. When you change the playback speed of a shot, Lustre duplicates or removes frames as needed so that the shot plays at the specified constant frame rate. Changing the speed changes the length of the shot, so you may need to trim the shot after you change the speed.

To change a shot's playback speed:

1. Select the shot in the Storyboard that you want to adjust.
2. Click Editing, and then click Edit.
   

    

   (a) Retrim button  (b) Retime slider  (c) Retime field  

3. Enable Retrim to trim the shot so that the same source in and out points are used. You can also trim the shot using the tools in the Edit menu.

   If you do not enable Retrim, the source out point changes shots. This is especially noticeable when you speed up a shot, since you may end up with black frames at the end of the adjusted shot. You can remove the black frames using the trimming tools. See Trimming from the Edit Menu.

4. Drag the Retime slider to the new playback speed or right-click on the Retime slider to enter a retime value in the Retime field.
5. Play back the shot to see the effect of the speed change.