About this result
The Quality prediction result indicates this area of the part can have unacceptable quality. The melt temperature at the point you selected is too low.
The Temperature at flow front result is one factor used to determine the Quality prediction result. The Quality prediction result is yellow or red in areas where the temperature is too low.
What problems can low temperature cause?
If the Temperature at flow front result is too low in a thin area of the part, hesitation or short shot can occur.
If it is too low in an area where weld lines are present, the weld lines can appear worse, and can be structurally weaker.
What to do next
There are some ways to ensure that part quality is acceptable.
Alter part thickness
Hesitation can cause low melt temperature. To avoid hesitation, increase the thickness of this area.
Alter the polymer injection location
Move the polymer injection location closer to the problem area, or add additional injection points. These actions improve the likelihood that all sections of a part fill and are of acceptable quality.
Alter the processing conditions of the selected material
You can change the recommended processing conditions. To improve the quality, increase the melt temperature of the current material.
Select a different material
Select a material with a higher melt temperature.