Use the Trim and Extend tools to trim or extend one or more elements to a boundary defined by the same element type. You can also extend non-parallel elements to form a corner, or trim them to form a corner if they intersect. When you select an element to be trimmed, the cursor position indicates the part of the element to retain. You can use these tools with walls, lines, beams, or braces.
|If you want to…||Then…|
|trim or extend 2 selected elements to a corner||click Modify tabModify panel (Trim/Extend to Corner). Select each of the elements. When selecting an element that needs to be trimmed to form the corner, make sure you click the part of the element to be retained.|
|trim or extend one element to a boundary defined by another element||click Modify tabModify panel (Trim/Extend Single Element). Select the reference to use as a boundary. Then select the element to trim or extend. If this element crosses the boundary (or a projection), the part that you click is retained. The part on the other side of the boundary is trimmed.|
|trim or extend multiple elements to a boundary defined by another element||click Modify tabModify panel (Trim/Extend Multiple Elements). Select the reference to use as a boundary. Then select each of the elements to trim or extend. For any elements that cross the boundary, the part that you click is retained. The part on the other side of the boundary is trimmed.|
|trim an element between 2 boundaries|| |
click Modify tabModify panel (Split Element). On the Options Bar, select Delete Inner Segment. Click 2 points on the element to define the desired boundaries. The inner segment is deleted, and the remaining pieces are retained. See Splitting Elements.
Preview for Trim/Extend to Corner tool
Result of Trim/Extend to Corner operation
Preview of Trim/Extend Single Element option with horizontal wall selected as the boundary
Result of Trim/Extend Single Element operation
Preview of Trim/Extend Multiple Elements option with horizontal wall selected as boundary
Result of clicking left-most vertical wall above the boundary, clicking next 2 walls below the boundary, and highlighting the wall on the right