Table of contentsNo headers
To modify an instance property of a wall sweep, you change the value of the corresponding parameter, as described under Modifying Instance Properties.
Common instance properties for wall sweeps are described below.
|Offset From Wall||The distance from the wall face.|
|Level||The level of the wall sweep. This property only appears for horizontal wall sweeps.|
|Offset From Level||The wall sweep’s offset from the level. This property only appears for horizontal wall sweeps.|
|Length||The length of the wall sweep. This is a read-only parameter. |
|Comments||Enter comments for the wall sweep. |
|Mark||A value to designate the particular wall sweep. This value must be unique for each wall sweep in a project. Revit warns you if the number is already used but allows you to continue using it. You can see the warning using the Review Warnings tool. See Reviewing Warning Messages.|
|Phase Created||The phase when the wall sweep was created.|
|Phase Demolished||The phase when the wall sweep was demolished.|