|Eccentricity||Bearing walls only. Specifies the offset from the wall center line to the bearing foundation center line.|
|Enable Analytical Model||Displays the analytical model and includes it in analytical calculations. Selected by default. See.|
|Rebar Cover - Top Face||Specifies the rebar cover distance from the wall top face.|
|Rebar Cover - Bottom Face||Specifies the rebar cover distance from the wall bottom face.|
|Rebar Cover - Other Faces||Specifies the rebar cover distance from the wall to adjacent element faces.|
|Estimated Reinforcement Volume||Specifies the estimated reinforcement volume of the selected element. This is a read-only parameter that only displays when rebar has been placed.|
|Length||Indicates the overall length. This is a read-only parameter.|
|Width||Indicates the overall width. This is a read-only parameter.|
|Volume||Indicates the volume of the foundation. This is a read-only parameter.|
|Elevation at Bottom|
Indicates the elevation used for tagging the Bottom of Foundation.
This parameter is affected by the family parameter Cap (see). The following image shows the difference between the Cap parameter enabled (in red) and disabled (in green).
The Elevation at Bottom measurement is taken from this setting.
This is a read-only parameter.
|Comments||A field for placing general comments about the foundation type.|
|Mark||A label created for the foundation. This value must be unique for each element in a project. Revit warns you when the number value is already used but allows you to continue using it. You can see the warning using the Review Warnings tool. See .|
|Phase Created||Indicates in which phase the foundation component was created. See.|
|Phase Demolished||Indicates in which phase the foundation component was demolished. See.|
|Identity Data (Analytical Wall Foundations)|
|Foundation Number||An identifier created for the analytical foundation. This value should be unique across Analytical Isolated Foundations and Analytical Wall Foundations in a project. Revit warns you if the number is already used but allows you to continue using it. You can see the warning using the Review Warnings tool. See .|
|Analyze As||Indicates the property type for structural analysis. Select either Foundation or Not for Analysis.|
|Family Type||The family type of the element.|
|Physical Material Asset||The name of a physical asset assigned to the material of the wall foundation (read-only).|