A result summary showing the analysis inputs and the results of each phase of the analysis or analysis sequence is generated for each analysis that is performed.
Select in the Study Tasks pane to view this summary, if the file comes from Autodesk Simulation Moldflow Insight or if the file comes from Autodesk Simulation Moldflow Adviser.
NoteResults summaries are included by default in results files exported from
Autodesk Simulation Moldflow Adviser.
TipIf you ran a sequence, click on the tab(s) at the top of the result summary to view the summary for each analysis.
Summary
All of the inputs that have been specified for the analysis are listed in the tab of the pane, and this section is used to verify that the inputs are correct. This summary contains the following information, depending on the analysis that is being run:
- Solver parameters
- Material data
- Process settings
- Model details
The tab records the following information:
- Mold dimensions
- Mold material
- Mold plate dimensions
- Mold offsets
The tab records the following information:
- Sprue dimensions
- Runner dimensions
- Gate dimensions
The tab records the following information:
- Cooling circuit dimensions
- Coolant information
The tab records the following results:
- Actual filling time
- Actual Injection pressure
- Clamp force area
- Max. clamp force during filling
- Velocity/pressure switch-over at % volume
- Velocity/pressure switch-over at time
- Estimated cycle time
- Total part weight at the end of filling
- Shot volume
- Cavity volume
- Runner system volume
The tab records the following results:
- Maximum clamp force during cycle
- Max. wall shear stress
- Total part weight
- Cooling time
- Cycle time
The tab records the following results:
- Maximum and minimum temperature variance
- Maximum and minimum cooling time variance
The tab records the following results:
- Maximum temperature, part
- Minimum temperature, part
- Average temperature, part
- Mold exterior temperature
Logs
The section reports various text results that relate to the analysis or analysis sequence. For specific information on a particular analysis, check the various Analysis Logs. For a Fill+Pack analysis, the following results are recorded to help you investigate the simulation.
The filling phase records the following results:
- Bulk temperature
- Wall shear stress
- Shear rate
The end of the filling phase records the following results:
- Time at end of filling
- Total weight
- Clamp force required
- Ram speed, recommended profile
- Bulk temperature
- Wall shear stress
- Frozen layer fraction
- Shear rate
The packing phase records the following results:
- Peak pressure
- Clamp force
- Total weight
- Bulk temperature
- Wall shear stress
- Volumetric shrinkage
- Total part weight
The end of the packing phase records the following results:
- Time at end of packing
- Total weight
- Bulk temperature
- Frozen layer fraction
- Volumetric shrinkage
- Sink marks, index