Product help with community knowledge
2013
Simulation Moldflow
HomeSimulation MoldflowEnglish2013HelpCommunicatorResultsFill analysis resultsMachine setup result

Simulation Moldflow

2012
2013
Help
Installation and Licensing
Insight
Insight 360
Adviser
Communicator
Autodesk Simulation Moldflow Communicator Help
Visual Learning
Introduction to Autodesk Simulation Moldflow Communicator
Release notes
Tutorial
Getting started
User Interface
Modeling
Molding processes
Analysis sequence
Materials and databases
Process settings
Results
Results (Procedure)
Results
Analysis log
Plot properties
Results Summary
Co-injection analysis results
Object Missing
Cooling Quality analysis results
Fiber Orientation analysis results
Fill analysis results
%Shot weight result
Air traps result
Air traps, including air vents result
Average temperature result
Average velocity result
Bulk temperature result
Bulk temperature, elemental result
Bulk temperature, nodal result
Bulk temperature at end of fill result
Real thickness, cavity result
Clamp force result
Clamp force centroid result
Confidence of fill result
Density result
Displacements, core result
Displacements, final shift result
Extension rate result (3D)
Fill time result
Flow rate, beams result
Flow rate result, shown in the analysis log
Frozen layer fraction result
Frozen layer fraction at end of fill result
Grow from result
Interface heat flux (3D Overmolding) result
Intermediate results
Machine setup result
Orientation at core result
Orientation at skin result
Orientation at bottom skin result
Orientation at top skin result
Percentile values in Fill analysis results
Polymer fill region result (3D)
Pressure result
Injection pressure result Pressure at end of fill result
Pressure at injection location result
Pressure at velocity/pressure switchover result
Pressure drop result
Quality prediction result
Re-melt zone, overmolded components (3D Overmolding) result
Re-melt zone, part insert result
Ram speed, recommended result
Shear rate result
Shear rate result (3D)
Shear rate, bulk result
Shear rate, maximum result
Shear stress at wall result
Temperature result
Temperature result (3D)
Temperature at flow front result
Throughput result
Unfilled cavity result
Velocity result
Velocity result (3D)
Vent region pressure result
Viscosity result
Volumetric shrinkage result
Weld lines result
Weld and meld lines result
Pack analysis results
Gas-assisted Fill+Pack analysis results
Gate Location analysis results
Design Adviser results
Injection-compression analysis results
Microcellular Injection Molding analysis results
Microchip Encapsulation analysis results
Molding Window analysis results
Optimization product results
Process Optimization analysis results
Reactive Molding analysis results
Runner Balance analysis results
Shrink analysis results
Sink Mark analysis results
Stress analysis results
Underfill Encapsulation analysis results
Warp analysis results
Birefringence analysis results
Reference materials
Troubleshooting guide
Glossary of Terms
Simulation TV
Videos
Community

Community Scoring

Was this page helpful?

Tag Tags0

This page has no tags

Page statistics

810 views,  1 edit(s),  344 characters(s) Page last modified 00:03, 5 Jun 2012 by contentconnector
How to add your knowledge

Machine setup result

    Table of contents
    No headers

    The Machine setup result is generated from a Fill analysis and shows the parameters that you should use on the injection molding machine, as determined by the analysis.

    Comments0

    Powered by MindTouch
    © Copyright 2013 Autodesk, Inc. All rights reserved.   Privacy Policy — Legal Notices & Trademarks